Recent content by Clyde K

They use to have a warehouse on Westinghouse Blvd, if you know somebody in the restaurant business you can by it by the pallet from them. I think it is around 50 or 60 bags per pallet.

Sure looks good!

Nice job on the cart!

The 1/4" pilot hole was drilled 2 3/4" from the end of the tab where the handle connects to the lid, (hope that makes sense). It takes a 7/8 hole for the Tel-Tru adpator kit to fit. Let me know if you need anything else.

Will do this evening.

I installed the BQ300- 2 1/2 stem on my OTG / CB. I think the short stem works the best because you will have less chance of it hitting or getting close to anything once the lid is in place. It has worked so good I am thinking about doing the same thing on my 22 WSM.

I use a modified fire place poker with a 90* end on it to adjust the bottom vent and tap the legs on my OTG / CB, sure helps with the bending over.

The main reason for the mod is to minimize the heat transfer to the fan, I don’t like it when the fan is hot or warm to the touch. (OCD kicking in) No mods were done the bottom it is still original.

First I have to thank PeterZ for helping me with info to complete this mod. The mount was made out of a camping bowl that I found at REI, Guru adaptor, bolt, nut and a couple washers. The bowl did seal up rather well after tightening it down. Now if I could just get a break in the rain maybe I...

Nice job on the work area!

Nice job on the shelf! I see one of them in my future.

Sure looks good!

Like timothy said if you pour it down the drain you are asking for trouble .When I use water I let it cool first then pour it into a 5 gallon bucket that has at least 2 if not 3 small trash bags in it, tie them up one at a time and in the trash can they go. No clogged pipes or varmints in the...

Congrats on the first cook!

Man those ribs look good!