BBQ Guru Mod

[Clyde K]

First I have to thank PeterZ for helping me with info to complete this mod. The mount was made out of a camping bowl that I found at REI, Guru adaptor, bolt, nut and a couple washers. The bowl did seal up rather well after tightening it down.

Now if I could just get a break in the rain maybe I could try it and some of that new Cowboy Lump I picked up at True Value yesterday.

 

[Dwain Pannell]

Very clean look. It reminds me of the one Pitmaster iQ uses which I really like.

 

[Bob Mann]

Very nice Clyde!

 

[PeterZ]

You got it bro =).
Looks good for now.

Peter

 

[Scott C.]

Looks great, but what benefit does this offer over the stock adaptor with the hole plugs? What does the inside look like?

 

[Clyde K]

The main reason for the mod is to minimize the heat transfer to the fan, I don’t like it when the fan is hot or warm to the touch. (OCD kicking in)



No mods were done the bottom it is still original.

 

[Mike Leiter]

I like it and sent you a PM

 

[Roy Payne]

I know this is an old thread. I really like this mod and was wondering how it is working out? I plan on getting a party q very soon and would like to get some input on this mod.

 

[JasonQuevada]

in for answers as well.

 

[AJStrider]

I keep thinking about doing this type of thing to cover up my One Touch vents on my kettles so I can throttle my intakes better for low smoking on them.