Recent content by Moses M.

You can remove the needle valve with a valve stem removal tool and throw the empty container in the re-cycle metal bin at the landfill.

I noticed last week when I did a test burn on my Brinkmann Smoke'n Pit Offset that the new Kingsford did burn hotter, but not as long as the older Kingford. With the old Kingsford, I could get stable temps (250*) and a 5 hour burn from one basket. With the new Kingsford, my pit burned hotter...

I've got an Unknown Hinge installed and it's much easier to lift the lid with the knob.

[/URL][/IMG]For those of you looking for a inexpensive side table for your Kettle. I use a set of RV Porta-Leggs along with an RV Pedestal Leg and a Base. I installed the Pedestal Leg into the Porta-Leggs and attached a Pedestal Leg Base to the under side the Weber 1800 Side Kick Table. Now I do...

Ordered two Unknown Hinges for 22.5 Kettle, they arrived in two days. Installed them and they work fine. They are the best things since the smokenator.

I have one that I just purchased a week ago. Tested it twice. Puts out too much smoke for me. Couldn't control smoke output with air pump. Tried a couple different air pumps. Purchased for $125. Will sell for $75.00. (mmiller@greenwood.net)

</div></BLOCKQUOTE>Will do just as soon as I learn how to (smile)

I purchased a Veritas Metal Bender that magnetically attaches to a vise and used some flat aluminum to make handle brackets for the Mid section. There is another post showing how to bend the metal using one's hand. The Veritas Metal Bender is a perfect inexpensive tool for making metal brackets...

Thanks Brian the handles arrived today. I purchased a Veritas Metal Bender that magnetically attaches to a vise and used some aluminum and made brackets for the mid section of the Smoker. Thanks. "U De Man"

To Cory L.: I purchased some extra probe clips off of Ebay a week ago. They are still listed on Ebay, Search for "Maverick Thermometer Probe Clip".