New WSM 22.5 in the cold.


 
S

Shand Glenn

New member
I have a brand new WSM 22.5. First cook today and it's windy and cold, 20 mph wind chills at 5. It seems to be cooking upside down. The top grate is 20-30 degrees colder than the bottom. Has anyone ever experienced this?

Thanks Much
Shand Republic, MO
 
timothy

timothy

TVWBB Olympian
Welcome Shand.
First thing I would ask is what are you cooking on each grate and how are you measuring grate temps?

Tim
 
timothy

timothy

TVWBB Olympian
Which way is your top vent facing.. into or out of the wind?

Edit: are the temps starting to even out? Heat rises so I would guess the Mav probe on top needs to be calibrated or it's placed to close to a cold butt.

Tim
 
Last edited:
Bob Ivey

Bob Ivey

TVWBB Emerald Member
Welcome to the group Shand. Try reversing the pit probes on the two ET-73's and see what the readings are. That will tell you if you have a calibration or probe issue. As Timothy said, you could have one pit probe to close to a piece of cold meat. Good luck and enjoy that WSM.. I love mine.
 
S

Shand Glenn

New member
Ok I will give that a shot. I have wondered if they are off. How do you calibrate the ET73 I have used them for years on A COS.
 
Bob Ivey

Bob Ivey

TVWBB Emerald Member
I could be wrong, but I don't think you can calibrate the Maverick et73. Someone chime in if I am wrong. I normally just use my HeaterMeter on my Performer as well as my WSM. On the HM, I can calibrate for probe differences.
 
S

Shand Glenn

New member
Thanks folks,looks like my problem is a bad ET-73. Great excuse to upgrade!! Now off to experiment with water, sand or clay pot!
 
timothy

timothy

TVWBB Olympian
Shand Glenn said:
How do you calibrate the ET73
Click to expand...

What I meant was to check the probe in boiling water or an ice bath and see if it's out of calibration. If it's off by a little than you can remember that and adjust, but if off by alot than time for a replacement because it could get worse.:)

Tim
 
Bob Ivey

Bob Ivey

TVWBB Emerald Member
Shand Glenn said:
Thanks folks,looks like my problem is a bad ET-73. Great excuse to upgrade!! Now off to experiment with water, sand or clay pot!
Click to expand...

In that case, you might consider checking out some of the control units out there. I love mine and it helps me to sleep during an overnight cook. Good Luck.
 
W

Wayne Dimirsky

TVWBB Super Fan
Welcome to the site. I'm just down the road from you in Aurora, MO. I have two 18.5 WSM's as well as a 14.5. The last few times I've used my WSM's, I've had problems keeping the temps up so I'm going to have to figure out what the problem is.

Wayne
 
You must log in or register to reply here.

 

Top