HOW TO: Cook Box Frozen Bolt Removal


 
I am happy that this HOW TO helped you out. I don't know the exact size of the cook box bolts as I have only rehabbed a couple of those over the years.
 
TomZ said:
New here. Digging up this old thread because this actually worked like a charm for me! Thanks so much for giving me the courage to try it! After spending a lot of time over multiple days replacing the drip pan support rails which had rusted out and broken (along with those screws), I noticed that there wasn't much left of the restraining bolt inside the cook box so I needed to tackle that as well. Used the dremel to cut off the rusted broken end of the bolt then tapped it out. It didn't show signs of loosening with each tap but then on the 8th or 9th attempt the bolt popped right out. What a relief! Now off to the box store to pick up a replacement cook box restraining bolt. Does anyone know the size of the OG bolt? Grill is an older Spirit E-310 with horizontal burners and control knobs on the side. After I get the cook box reattached she's getting new burners, ignitor and thermometer. Have all of those just waiting to be installed. Thanks!
Click to expand...
If it’s what I’m picturing I would guess it’s a 2” bolt, but could you post a picture of the grill so that others can chime in too?
 
I think that grill has a front and rear bolt holding the cook box in and it might be a specialized bolt. But I think a standard hex bolt would work too. I might have a grill I can check.
 
I just did the broken cook box bolt on my Genesis Silver A.

I managed to get it out quite easily using a MAP torch and a pair of vise grips. I heated it up then put the vise grips on the end of the bolt inside the cook box. With a few twists back and forth it came free.

To replace your bolt, you need a standard 1/4-20 bolt, 2" long, a nut and a washer.

The thing I didn't get at first is "what am I dealing with here? Is it threaded into the hole?" Watching Bruce's video shows that it's not threaded because you can push it through. It's actually only held in there by rust and oxidation. Not as bad as you might think. I would not put in all of the time it takes to drill one out.


20251009_153632.jpg20251009_153742.jpg
 
Dave-MI said:
I just did the broken cook box bolt on my Genesis Silver A.

I managed to get it out quite easily using a MAP torch and a pair of vise grips. I heated it up then put the vise grips on the end of the bolt inside the cook box. With a few twists back and forth it came free.

To replace your bolt, you need a standard 1/4-20 bolt, 2" long, a nut and a washer.

The thing I didn't get at first is "what am I dealing with here? Is it threaded into the hole?" Watching Bruce's video shows that it's not threaded because you can push it through. It's actually only held in there by rust and oxidation. Not as bad as you might think. I would not put in all of the time it takes to drill one out.


View attachment 120847View attachment 120848
Click to expand...
I always get them to come right out with a torch and a little persuasion myself. The thought of drilling them out just makes my brain hurt.
 
I used a torch and Bruce's technique for a long time to no avail on a Silver B box. To make matters worse, there was a pre-existing chip in the aluminum by the bolt so I was worried about busting a big hole out of the cookbox. I ended up drilling it out. I used a small cobalt bit to get through a small hole and then a larger bit to clean it out. Getting the first bit through was really difficult and took a lot of time. The whole ordeal was really a pain. It all worked out ok but I would recommend doing any other method first.
 
You must log in or register to reply here.

 

Back
Top