Robert-R
TVWBB Diamond Member
Have been wanting to try making faux pastrami. Used this recipe: http://www.virtualweberbullet.com/cornedbeef.html
Brisket prepped as per and onto the 14.5. Full charcoal ring of KLump w/ pecan & cherry. Temps averaged 275*.
It hit the stall 2 hours later at 155*. Watched it for another hour. Recipe said to wrap at 165* - became concerned, so I wrapped it at hour 3. Temp was 156*. Pig shots went along for the ride.
10 hours into the cook, it's at 195*. Recipe says to pull it, but it's not probe tender at thickest part of the flat. Check it again 20 minutes later. Not yet... give it another 20 min...... nope..... yet another 20 min - the temp is 199* & still no tenderness. Sheee.... so I pull it.
I let it cool for a few hours & then into the fridge.
The next day - time for a sammy:
Well, it's overcooked. Figured as much. It tastes good. Probably make a good sandwich anyway.
Not too bad! Damn good sammy.
fwiw - I've never had much luck smoking a small flat. This wasn't any different. Almost expected the result. Probably should have been probing around 180*.
Have bumped up on another way to do this & will try that method next time.
Brisket prepped as per and onto the 14.5. Full charcoal ring of KLump w/ pecan & cherry. Temps averaged 275*.

It hit the stall 2 hours later at 155*. Watched it for another hour. Recipe said to wrap at 165* - became concerned, so I wrapped it at hour 3. Temp was 156*. Pig shots went along for the ride.

10 hours into the cook, it's at 195*. Recipe says to pull it, but it's not probe tender at thickest part of the flat. Check it again 20 minutes later. Not yet... give it another 20 min...... nope..... yet another 20 min - the temp is 199* & still no tenderness. Sheee.... so I pull it.

I let it cool for a few hours & then into the fridge.
The next day - time for a sammy:

Well, it's overcooked. Figured as much. It tastes good. Probably make a good sandwich anyway.

Not too bad! Damn good sammy.
fwiw - I've never had much luck smoking a small flat. This wasn't any different. Almost expected the result. Probably should have been probing around 180*.
Have bumped up on another way to do this & will try that method next time.
Last edited: