Recent content by TMorris

I found a 3D printed mount (would keep it external to the grill): And one example where someone cut in to their grill to accomplish: Think I may see if I can find a decent size ABS project box and make something stand-alone that I can use.

Hi all, A relative had given me an iGrill 3 setup, new-in-box, because they had bought it thinking it would work for an older Genesis grill. I too have an older Genesis grill which doesn't have the mounting point for the iGrill system, but when I look at what's in the box, it doesn't seem...

Thanks. I priced it for quick sale - $125, which is exactly the price I paid for the new one. Broke even on the swap. I probably could have spent some time cleaning it up, but it had the rusty frame right at the bolt for the fire box which I did not want to spend the time repairing. Looking...

Thanks! So far, all I see is a little surface rust from where it looks like a can of cooking spray sat for a little while (rust ring). Could probably polish it off the paint - will give that a shot. I'm hoping if I keep it covered and on the deck it's on, that I will avoid a lot of rust on...

Finished product.

Emblem following clear coating with Duplicolor clear engine enamel.

I will say, it was not easy. A couple of hours of hand sanding for sure.

I confirmed last evening that this is a 2013 model (serial number beginning with AT).

In this case, the underlying emblem is aluminum (2013 S330) - may be different for different grills. I am thinking of leaving it just as-is. I can always come back and sand and clear at some point in the future if the aluminum oxidizes or the inset letters start to peel.

@Richard in NS It was not easy, but I flat sanded all of the chrome off the face of the emblem, starting with 80, then 100. Finished with an orbital sander at 220. I had used some paint stripper before sanding which took off all of the black paint in the inset. I am not sure if I’m going to...

I'm probably overthinking this, but I need a propane hose for connecting my grill to a quick disconnect tied in to my propane tank. It needs to be 3/8" flare female on one side and 3/8" NPT male on the other. Regulator not required. I'm currently using a 5 ft hose, but it's about 1 ft too...

I used the high temp rust oleum in the silver or aluminum color. Don’t think it looks too bad.

Thinking I’m going to stick with the S330. Gave it a full cleaning, top to bottom, and amazed with how clean it actually is. Used some Soft Scrub on the stainless and it came out like new, no scratching. Repaired the igniter with some new electrical terminals. Painted the rings on the handle...

No, I misspoke. That’s all painted.

Photos attached.