ChadVKealey
TVWBB Pro
I'm not daring enough to smoke a fresh ham yet, and the family just loves the spiral-sliced job we get from Wegman's each Christmas, so that's what we got again this year. Due to shortness of oven space (our oven is smaller than the in-laws, where we've spent the last few Christmases), I was planning to heat/glaze the ham on my WSM.
In the oven, I'd normally go about 2 hours at 350 to be sure it's heated through, so I assume the same time & temp would work on the WSM? I'm probably going to foil it for the first hour to get it most of the way there, then start laying on the glaze in 15 minute intervals until it's done. Obviously, it's already smoked, so I'm not planning to use any smoke wood, just a 50/50 mix of lump and briquettes. I'm also guessing I should leave the water pan (foiled with foil-wrapped bricks) in as a heat shield so the ham doesn't burn to the bottom of the roasting pan.
Any thoughts or suggestions?
In the oven, I'd normally go about 2 hours at 350 to be sure it's heated through, so I assume the same time & temp would work on the WSM? I'm probably going to foil it for the first hour to get it most of the way there, then start laying on the glaze in 15 minute intervals until it's done. Obviously, it's already smoked, so I'm not planning to use any smoke wood, just a 50/50 mix of lump and briquettes. I'm also guessing I should leave the water pan (foiled with foil-wrapped bricks) in as a heat shield so the ham doesn't burn to the bottom of the roasting pan.
Any thoughts or suggestions?