I just built a HM 4.2.4 and everything works great. now I would like to extend my servo/blower/probes to the end of a cat5 cable. I see on the HM board where I connect the blower and servo on the RJ45 jack but I don't see any instructions on extending the regular ET73 probes... do I just use a jumper from the mono jacks on the board and patch the signal leg to one of the unused RJ45 pins? use common ground? as I dont see any traces to those empty RJ45 pins...
NOT using any TC stuff BTW
Also... where do I attach the ambient temp probe if i want to add one to my HM 4.2.4? i dont see an open slot?
Thoughts?
NOT using any TC stuff BTW
Also... where do I attach the ambient temp probe if i want to add one to my HM 4.2.4? i dont see an open slot?
Thoughts?
Last edited: