Bruce TVWBB 2-Star Olympian Friday at 2:41 PM #61 Whatever works. I mixed and matched on my last rehab/flip.
DanHoo TVWBB Olympian Friday at 3:41 PM #62 I like the black table ends, especially with a maroon lid.
Samuel TVWBB Wizard Friday at 4:12 PM #63 DanHoo said: I like the black table ends, especially with a maroon lid. Click to expand... I like them too Dan, I originally was going to gray on gray, but since I have the correct black trim pieces, I will keep it blacked out.
DanHoo said: I like the black table ends, especially with a maroon lid. Click to expand... I like them too Dan, I originally was going to gray on gray, but since I have the correct black trim pieces, I will keep it blacked out.
J Jim Weber TVWBB Super Fan Friday at 4:23 PM #64 Samuel said: Curiosity got the best of me. The Black Out Edition. View attachment 95761View attachment 95762View attachment 95763 Click to expand... I've always like the maroon lids and with the blackout --- it looks even better! Nice one.
Samuel said: Curiosity got the best of me. The Black Out Edition. View attachment 95761View attachment 95762View attachment 95763 Click to expand... I've always like the maroon lids and with the blackout --- it looks even better! Nice one.
Samuel TVWBB Wizard Yesterday at 6:23 AM #65 Bruce said: Whatever works. I mixed and matched on my last rehab/flip. View attachment 95764 Click to expand... Bruce, is that aluminum sheeting on the bottom? If so, how did you mount it to the bottom?
Bruce said: Whatever works. I mixed and matched on my last rehab/flip. View attachment 95764 Click to expand... Bruce, is that aluminum sheeting on the bottom? If so, how did you mount it to the bottom?
Bruce TVWBB 2-Star Olympian Yesterday at 7:21 AM #66 I welded in the front and back cross members and then cut the sheet aluminum slightly smaller than the outside measurements L and R. Then, I simply revited it to the bottom of the cross members with 1/8x1/8" aluminum rivets.
I welded in the front and back cross members and then cut the sheet aluminum slightly smaller than the outside measurements L and R. Then, I simply revited it to the bottom of the cross members with 1/8x1/8" aluminum rivets.