Wade Leishman
TVWBB Member
Bought a gasket kit for my older 18.5" WSM and tried to install over the weekend...I watched the YouTube vid (which wasn't on a WSM), Followed the directions and on the lower section I thought everything went OK, UNTIL I tried to place the middle section back onto the lower bowl... and it's tight... like I'm unable to get it seated tight, like it no longer fits at all tight... I'm guessing that I could get it in there with a little persuasion (like a 2x4 and rubber mallet type persuasion), but not sure it would ever come out (making adding coal and wood, etc difficult). Did I screw something up, or ?
And if I pull the gasket off, then I guess I'd get to scrap/grind off all the messy red RTV and try again?
-Wade
And if I pull the gasket off, then I guess I'd get to scrap/grind off all the messy red RTV and try again?
-Wade