Hi,
Didn't know if I should start a new thread but decided it might be best Took the box out of the Frame, but when I removed the box I did notice rust on the inside of the left side crossbar where the screw that attaches to the box. I do want to say that the outside of that part where screw enters is solid and both the box , outside and inside at that point are solid. Can't use the Encapsulator due to the high heat. Here is what I was thinking of doing. Try to remove crud from inside the tube, use high heat primer, 2 coats then 2 coats high heat black. When dry spray inside the hole with Fluid Film, then re-attach the box after painting. Any other suggestions that would be helpful.
Didn't know if I should start a new thread but decided it might be best Took the box out of the Frame, but when I removed the box I did notice rust on the inside of the left side crossbar where the screw that attaches to the box. I do want to say that the outside of that part where screw enters is solid and both the box , outside and inside at that point are solid. Can't use the Encapsulator due to the high heat. Here is what I was thinking of doing. Try to remove crud from inside the tube, use high heat primer, 2 coats then 2 coats high heat black. When dry spray inside the hole with Fluid Film, then re-attach the box after painting. Any other suggestions that would be helpful.