In the process of building the HeaterMeter for my new Kamado Joe. I already have the Pi Zero W so I figured I'd get a head start and load the firmware. I've tried a few different configurations and none seem to work. I'm not getting a wifi connection. I am doing this all without a screen at this point. I keep sniffing my network to see if any new devices populate and they don't. Then I was going to SSH and set up VNC. I plan on running this withough an LCD. Does the firmware only completely load if the heatermeter board is set up? It's not a huge deal as my board should be delivered tomorrow. Just wanted to make sure I wasn't having a different issue.
Thanks!
Brent
Thanks!
Brent