Jay D in Jersey
TVWBB Wizard
I've had this 2013 S-210 which I picked up used off of CL on the deck of our beach house for three years now and it's holding up great thus far. It's a very harsh environment. 35 yards from Cape May County, NJ back bay, North facing deck. Anyway, I ordered new stainless flame tamers as I doubt what's left of the original porcelain steel ones will make it to July 4th. I am going to clean and grease the valves. I have a spare set of burner tubes but I don't forsee using them for a long while. The lid end caps are decent as is the box and 95% of the frame....except for the base in the front center below the lid handle. The gray paint is bubbling up and separating from the steel. My thought was to put my angle grinder with an abrasive wheel or wire brush to strip away all effected areaes. Clean and lightly sand, tape, prime and paint. Is that how you guys handle this situation?
Last edited: