WTB left side table slats.


 
E

ErikMn

TVWBB Member
Looking to buy the wood slats for the left side work table on a genesis 1000. Anyone got any they aren't going to use?
 
Timothy I dunno figured they might not be the best cuts with a circular saw and I dont mind sanding down some wood to refinish.

Rich, wood.
 
Do you have accurate measurements? I might be able to borrow a buddy's shop and make you a set, what material are you thinking of?
Don't know what it might cost but, the dimensions would help. You can put finish on and drill as needed, right?
 
Last edited:
Well maybe this will work. I grabbed my 19.2v craftsman circular saw and threw the little guide on it and cut some common board I had luying around. I thought the cuts would be a lot worse and crooked. Just need to sand the rough edges and use the same gel stain and clear I used on the original handle and I might be in business. I think the originals were made out of some kind of cedar though.

dgJlOmZ.jpg
 
You must log in or register to reply here.

 

Back
Top