Thermometer Installation

  • Thread starter Thread starter Guest
  • Start date Start date

 
Status
Not open for further replies.
G

Guest

Guest
What length of probe is best to mount in the lid of my WSM? I'm thinking of a 2 1/2" long stem, since it will be closer to the lid. I will use a Polder at the grate to help me estimate the diference between the two ( Lid temp and grate temp).
Will this length be okay or should I go longer on the stem?
 
In my opinion, the only issue is the stem being so long that it bumps into the food, say a beer butt chicken. I like a 4" stem, but 2-1/2" would be OK, too. I don't think there would be any difference.

Regards,
Chris
 
Thank you Chris. I went to FAQ's to due some research on the installation process, but there is always a slight doubt on my part before I start a project. Confirmation from you makes the selection on the length of the stem alot less worry some.Thanks again and thank you for this great website. Take care and be well !
 
Status
Not open for further replies.

 

Back
Top