Question about putting this together EX6

[LanceJ]

I’m using the BILT app and I selected smokefire 2022. I’m at the part though where I take the panel off to get to what I think is going to be the glow plug. On the BILT app though the screws to take out are on the sides and on mine they are Phillips screws on the back of the panel. Also when I open the panel the inside where the two wires are is different from the app. I’m sure I’m in the right place but the app looks different.

 

[Bruno]

I think you need to use the first one that just says SmokeFire.

 

[LanceJ]

I think you need to use the first one that just says SmokeFire.

That was it. Thank you. This is supposed to be a second generation so I thought I needed to use 2022. Sorry

 

[Lew Newby]

That was it. Thank you. This is supposed to be a second generation so I thought I needed to use 2022. Sorry

2022 is the stealth. Gen 2 came out winter of 2020.

 

[LanceJ]

2022 is the stealth. Gen 2 came out winter of 2020.

Gotcha. Thank you

 

[LanceJ]

Ok finally got it. There is a large gap on the right side of my lid though. Are we supposed to adjust these

 

[LanceJ]

Are these the screws that people are saying to take out? The three with the thin wire.

 

[Bruno]

Are these the screws that people are saying to take out? The three with the thin wire.

Those are them. One at a time they hold the auger.

 

[Lew Newby]

Ok finally got it. There is a large gap on the right side of my lid though. Are we supposed to adjust these

Loosen the hinges and then get the lid seated correctly.