So for the better part of 15 years I have been using a Weber gas grill, and I have it down pretty good.
Recently started getting bugged by my wife about how much better charcoal flavor is after visiting a friends outing, so after some research I went out and bought a Weber Kettle.
Now I feel like I'm pretty smart, and I am fully aware that this is not rocket science, but after countless hours of research and multiple grilling attempts, I gotta say I'm feeling really really stupid here, as I cannot seem to get this right.
I started with match lite, and moved over to a weber chimney (I believe the full size one that was $20 at Lowe's) and lump charcoal as I was starting to feel uneasy about the amount of chemicals in match lite.
Heres the issue. I filled the chimney up to the top with Royal Oak Lump charcoal and started the fire. Waiting the 10-15 min the coal burned down a bit but got ashy, so I dumped it.
Covered and that baby was smokin hot. The thermometer (which I am aware is going to be somewhat inaccurate) was reading 500+
5 min later I put my chicken on and the temp plummets to barley 300, no smoke and feels like hardly any heat coming off the lid.
Vents all full open, kept lid on (I understand the on off on off is a no go), but there were no embers to speak of in the coal. I tried not to spread it thin, but honestly there seemed to be very little charcoal in the grill. I would say maybe 1/4 of the grill grate had charcoal?
So my assumption is not enough charcoal...
My question is, how am I to have more in there? The chimney was full when I started, slightly lower when I dumped, but I can assure you that little that was missing was not going to be the answer.
Should I have a few handfuls of cold coal sitting on the grate before I dump the chimney?
Looking for some advise, as all the youtubbing in the world has brought me to the conclusion that I am either an idiot or just really bad at life as they seem to use one chimney full and have plenty
Recently started getting bugged by my wife about how much better charcoal flavor is after visiting a friends outing, so after some research I went out and bought a Weber Kettle.
Now I feel like I'm pretty smart, and I am fully aware that this is not rocket science, but after countless hours of research and multiple grilling attempts, I gotta say I'm feeling really really stupid here, as I cannot seem to get this right.
I started with match lite, and moved over to a weber chimney (I believe the full size one that was $20 at Lowe's) and lump charcoal as I was starting to feel uneasy about the amount of chemicals in match lite.
Heres the issue. I filled the chimney up to the top with Royal Oak Lump charcoal and started the fire. Waiting the 10-15 min the coal burned down a bit but got ashy, so I dumped it.
Covered and that baby was smokin hot. The thermometer (which I am aware is going to be somewhat inaccurate) was reading 500+
5 min later I put my chicken on and the temp plummets to barley 300, no smoke and feels like hardly any heat coming off the lid.
Vents all full open, kept lid on (I understand the on off on off is a no go), but there were no embers to speak of in the coal. I tried not to spread it thin, but honestly there seemed to be very little charcoal in the grill. I would say maybe 1/4 of the grill grate had charcoal?
So my assumption is not enough charcoal...
My question is, how am I to have more in there? The chimney was full when I started, slightly lower when I dumped, but I can assure you that little that was missing was not going to be the answer.
Should I have a few handfuls of cold coal sitting on the grate before I dump the chimney?
Looking for some advise, as all the youtubbing in the world has brought me to the conclusion that I am either an idiot or just really bad at life as they seem to use one chimney full and have plenty
