Hey all, been reading the forums a few months now and was hoping it's ok to ask a few questions here about hardware. (Probes\Thermocouple\MountingPipe)
First off this is mostly for my WSM 18.5, but later plan on maybe a 2nd damper for my Kettle. I also plan on the "Cat Dish" design being I am not ready (Yet) to start drilling holes into my smoker.
My 4.3 (Soldered +Fan and PSU)) shipped today and I started printing my Adapt-a-Damper last night. I already had a few PIs and SD cards laying around and found an SG90 Servo in my Arduino kit.
I still need to get the Home Depot parts and the Probes\thermocouple. That is where my question comes in...
What do people recommend for the probes and thermocoupler? (Most of the treads are pretty old so wanted to see if anything changed)
Also for the 1" pipe fitting, what are people using? I saw the 1" threaded to Conduit adapter but then the pipe is only listed in 10ft length, is there other pipes people are using that are shorter?
Thanks, as soon as parts get here I am sure I will have more questions.
Tom
PS: Thanks to all the Devs and Testers that made this possible.
First off this is mostly for my WSM 18.5, but later plan on maybe a 2nd damper for my Kettle. I also plan on the "Cat Dish" design being I am not ready (Yet) to start drilling holes into my smoker.

I still need to get the Home Depot parts and the Probes\thermocouple. That is where my question comes in...
What do people recommend for the probes and thermocoupler? (Most of the treads are pretty old so wanted to see if anything changed)
Also for the 1" pipe fitting, what are people using? I saw the 1" threaded to Conduit adapter but then the pipe is only listed in 10ft length, is there other pipes people are using that are shorter?
Thanks, as soon as parts get here I am sure I will have more questions.

Tom
PS: Thanks to all the Devs and Testers that made this possible.