John Angelini
TVWBB Member
Anyone have any suggestions for how to protect the gas line on this? Or am I over thinking it and the gas line should go over the top where there are no sharp edges on the sheet metal?
Edge protectors for gas line?
- Thread starter John Angelini
- Start date
Brett-EDH
TVWBB Olympian
if you're super concerned: https://www.homedepot.com/p/Everbil...Slit-Pipe-Insulation-K7PXE048058HD1/327682623
place this over the metal and problem solved.
place this over the metal and problem solved.
Last edited:
I see your concern.
You add clear plastic to the edges. Maybe something like what you would use for a paper binder.
Or you could buy an armored regulator hose assembly
John Angelini
TVWBB Member
Sharp enough. The white lines on the hose is where it scraped along the edge of the metal. And the shavings from the hose.
I'll check the assembly manual for the grill and see what it says about how to route the hose and I might end up with the edge protectors.
I'll check the assembly manual for the grill and see what it says about how to route the hose and I might end up with the edge protectors.
Anthony Spitzer
TVWBB Pro
You could split a piece of small diameter vacuum hose open and glue it over the edge to make an edge protector.
John Angelini
TVWBB Member
I think it's time to pimp out the grill. CHROME. 
Timothy F. Lewis
TVWBB 1-Star Olympian
I like Brett’s suggestion, cheap and very durable. Easily replaceable whenever needed.
Timothy F. Lewis
TVWBB 1-Star Olympian
Even pretty! I like that!!!
John Angelini
TVWBB Member
I couldn't do it. Too much bling for the grill.
Got to the auto parts store and found some clear door edge guards so I went with those. I think they'll do the trick nicely.
Got to the auto parts store and found some clear door edge guards so I went with those. I think they'll do the trick nicely.
Timothy F. Lewis
TVWBB 1-Star Olympian
Not bad! But, remember…
“No guts, no glory!
“No guts, no glory!
Bruce
TVWBB 2-Star Olympian
Maybe something like this. But from what I can tell, the gas lines were intended to be run through that opening.
If you don't have a menards nearby, you can probably find the same stuff at a Lowes or HD or Amazon.
If you don't have a menards nearby, you can probably find the same stuff at a Lowes or HD or Amazon.
Cody Bratton
TVWBB Gold Member
For protecting edges, get a piece of reinforced rubber hose (coolant hose, or something meant to handle pressure) from the hardware store and cut a slit in it with a sharp razor blade. Slides right on and will be far cheaper than anything else.
Cody Bratton
TVWBB Gold Member
I've done it seemingly hundreds of times, to protect wires running thru holes, and to clean up appearances of edges