I knew better but did it anyway, lifted the grill by the end of the table while 20lbs of meat was on it. The table is old and more brittle so this was enough to put a small crack on one side of the table. Not a big crack but I can feel it give when I lift up on it to roll the grill, something I need to do often so I must figure out a repair and reinforce the plastic table.
Any suggestions would be appreciated. I pulled the table off to make the repair easier so just looking for ideas. Thx
By the way, grill is 15 years old so out of warranty and assume little to no chance they would send a new one for free, right? Never considered they would but I see several here have had theirs covered but don't know in or out of warranty.
Any suggestions would be appreciated. I pulled the table off to make the repair easier so just looking for ideas. Thx
By the way, grill is 15 years old so out of warranty and assume little to no chance they would send a new one for free, right? Never considered they would but I see several here have had theirs covered but don't know in or out of warranty.
Last edited: