Search results

spare ribs, first cook using the heatermeter on the wsm along with the first attempt of Orange Marmalade Sriracha Wings on the kettle.

i don't think 8081 will work, i also tried to setup on that port with no luck. 80 works and more info on ports is here: https://github.com/CapnBry/HeaterMeter/wiki/Network-ports try forwarding to 80 and then check at http://myhmpi.ddns.net:80

what port number are you forwarding and what address are you entering to view? i have mine set to port 80 i think 443 also works. in the netgear advanced tab from the port forwarding screen enter the heatmeter ip address then click add. once it is added click edit select protocol tcp/udp and...

It's Alive. quick update, lcd pins 1-2 were shorted on the bottom of the board. now it powers on again, still blocks on the lcd. i might quit while i am ahead.

power supply is good, still no signs of life. not sure what would have changed just adding solder to the lcd pins. any help appreciated. pi powers up separate from the heatmeter, mated together the heatmeter does not power on. worked ok with no screen until i added more solder to the lcd pins

i added more solder to the lcd pins and now it will not even power on.

thanks to all for the help, i think i am just stumped. resoldered on the boards as suggested then removed an replaced the lcd. the new lcd shows the top row of squares only. everything else seems to work- probes and the linkmeter app. i may just run without the lcd.

the first time i put the lcd on backwards, i cleaned both surfaces and reattached with the correct orientation. however, i may not have taken as much time as i should have to correct. please confirm which are the d & e pins? i am hoping to find time to work on this over the weekend. thanks all...

there is continuity between lcd pins, i think it is solder between the two board where they meet.

you can be critical of the soldering, when i first powered on the heatmeter i was surprised the lcd was the only thing that didn't work : ) on the photos i did not have a lot of solder in anticipation of having to remove the lcd and start over. i did add more solder to all lcd pins, still no luck

adjusting contrast changes intensity but only squares are displayed. will post pictures later today, appreciate the help. here are pictures, on the first attempt i installed the lcd backwards and after correcting it shows squares instead of status...

completed the build and all works except the lcd monitor. the monitor has power but only displays two rows of black squares. not sure but i think it might be a solder short between the two boards. question is should i replace/resolder the lcd or just run through the app? am i missing anything...