Recent content by DKellogg

Firing up the old HM for a Labor Day brisket. It's been ages since I've had her up and running. Tried connecting via web with IP (and also PitDroid), and although it's reporting IP @ startup, I cannot connect. Did a search and noticed Bostwick had similar issue, but no resolution...

I am using a basket. On my leaky as hell CG i could get 2-1/2 hrs. Thsts enough to get a decent amount if shuteye during comps.

Has no one mounted the blower through the "inside" wall of the firebox

Hey all... So, I've recently upgraded to an OK Joe Longhorn from the Chargriller. On the CG I was using a dog bowl adapter off the ash drawer/ damper. For the LH, I've fabricated a 16 ga plate with a 1-1/2" close nipple threaded into it to replace the damper plate (so that I can always go...

Wait... does that go over the adapter thats on thingiverse?

That looks great! PM sent

That would be awesome.

So I've got a buddy that's going to print for me. From your perspective, do you see a benefit with eith pipe or fitting? If not, i think I'd prefer to have it pipe sized to fit inside a fitting. OD for pipe 1.900". ID for fittings is 1.912" at the entrance and 1.894" at the "bottom"...

Regarding the 15 cfm versions. A couple of questions: 1. What is the adapter intended to connect to. I use a 1-1/2" pvc female adapter on a 1-1/2" SST close nipple. Will the adapter fit either in the 1-1/2" pvc fitting, or on a 1-1/2" pvc pipe? 2. Can the TP SG90 servo be used in lieu of...

you need a damper so that when the fan is off, the vent is closed.

Was looking at those, and will probably get one, however, one of these multi-function jobbies is also appealing. My only question is the Ah rating. It's advertised as 26,000 mAh, but how do you tell at what voltage that is? I would hope it's at 12v, since that's the natural voltage of this...

WOW! That's nothing like my threads look. Thanks Steve.

Can someone post picture of the threaded end as it comes off the printer, and after cleanup. Had a buddy print mine, but threads aren't great, so I wanted to see what you guys (that printed yourselves) ended up with so I can get an idea about how it should look coming out.

So Bryan, i was cooking at Hudson Valley Ribfest this weekend..... i think a more usedful alarm would be: if not in startup mode and average output is greater than or equal to x% for y sec sound alarm.

That logic seems correct to me. Startup is initialized any time the setpoint changes, correct?