Recently took my Heatermeter out of winter storage for use today, and swapped out my old ET-72/73 air probe thermistor for a Thermoworks Pro-Series one (TX-1003X-AP). I changed the probe coefficient preset to the TX-1001X-OP. However, when I try to plug in my ET-72/73 probes for the meat into any of the Probe 1/Probe 2/Probe 3 slots, the air probe gets disabled, and registers as not detected. The ET-72/73 will read temp just fine, but the air probe will not. As soon as I unplug the food probe, air probe starts working just fine. I was wondering if there's some sort of compatibility issue between the TX-1001X-OP and the ET-72/73? Do I need to buy a matching set of Thermoworks Pro-series food probes to be compatible with the air probe?
Also (not sure if it's normal), on the "Probe Setup" page, when nothing but the thermistor is plugged in, Probe 1 is disabled, while Probe 2 and 3 are present. I can't seem to enable Probe 1, as the save will not work.
Also (not sure if it's normal), on the "Probe Setup" page, when nothing but the thermistor is plugged in, Probe 1 is disabled, while Probe 2 and 3 are present. I can't seem to enable Probe 1, as the save will not work.