Summit IR burner won't stay lit


 
I would love to see what would happen if you simply put the old one back in now and tried it.
 
LOL. Thanks Eric. Very interesting and I would love to know the exact reason. DId you every try to make sure nothing was clogging it or partially obstructing the orifice?
 
Bruce said:
LOL. Thanks Eric. Very interesting and I would love to know the exact reason. DId you every try to make sure nothing was clogging it or partially obstructing the orifice?
Click to expand...
It's hard to tell. I can clearly see through it when holding up to the light. The hard part is there is so much junk on it I was afraid to try and poke it clear and ends up with too large a hole. After looking again, I think the new one is slightly bigger. But even an EXTREMELY small difference in such a small joke would be a very large percentage different in gas flow. I would think at least
 

Attachments

  • PXL_20230915_191142026.jpg
    PXL_20230915_191142026.jpg
    74 KB · Views: 7
  • PXL_20230915_191125822.jpg
    PXL_20230915_191125822.jpg
    76.2 KB · Views: 7
  • PXL_20230915_191118119.jpg
    PXL_20230915_191118119.jpg
    85.5 KB · Views: 7
I had similar troubles on my original Genesis II. Weber rep told me to remove them and do a good clean on them. I did with some BrakeKleen and compressed air. Worked like a champ
 
You must log in or register to reply here.

 

Back
Top