Got my IQ 110 this week and loving it. However, it's not really practical to hang it from the door knob, so I got a little creative.
I got a small shelf bracket, 3/8 threaded steel rod, 2 washers and 3 - 3/8 inch bolts at Ace. Bent the top of the bracket 90 degrees back where the top mounting hole was. Then I cut off a 5 inch piece of the rod, put 1 bolt halfway down as a stop and height adjustment, and bolted the top with the other 2 bots and washers. 10 minutes top in the garage and here is the result:
Slides right into the garage door handle...
IQ 110 is now a safe 5-6 inches away from the cooker...
A little generic, but it works much better than the bent coat hanger I was using.
I got a small shelf bracket, 3/8 threaded steel rod, 2 washers and 3 - 3/8 inch bolts at Ace. Bent the top of the bracket 90 degrees back where the top mounting hole was. Then I cut off a 5 inch piece of the rod, put 1 bolt halfway down as a stop and height adjustment, and bolted the top with the other 2 bots and washers. 10 minutes top in the garage and here is the result:
Slides right into the garage door handle...
IQ 110 is now a safe 5-6 inches away from the cooker...
A little generic, but it works much better than the bent coat hanger I was using.
