Just got my 3D prints back and put the servo and blower together. Just setting everything off of manual fan mode for now. Blower works fine, ramps up as it should. However, the servo with every change in percentage will jump and chatter and even move to wayyyy off where it should be. I've even tried taking the servo out of the blower housing to see if anything was bound up while mounting and got the same results.
I had done some searching and looks like the power supply is one potential problem area. I have been using one I found in my random electronics/wire box. Someone had success with this power supply fixing some servo problems in another thread so it will be here Monday. http://www.amazon.com/exec/obidos/ASIN/B00Q2E5IXW/tvwb-20
I should note that the servo does not make any noise/chatter/move sporadically except when the % output is changed. I'm uploading a video to YouTube and will post a link shortly.
I had done some searching and looks like the power supply is one potential problem area. I have been using one I found in my random electronics/wire box. Someone had success with this power supply fixing some servo problems in another thread so it will be here Monday. http://www.amazon.com/exec/obidos/ASIN/B00Q2E5IXW/tvwb-20
I should note that the servo does not make any noise/chatter/move sporadically except when the % output is changed. I'm uploading a video to YouTube and will post a link shortly.