RalphTrimble
TVWBB Diamond Member
I've seen some strange behavior of my HM that I would like to report in case it might be a bug.
Occasionally I have had the probes reset to DISABLED and the display setting change from 4-line to two line. It's not a big deal cause if I change them back and save everything is corrected. It is a bit odd and frustrating at times though.
Today I noticed reproducible behavior that I figured I should report
I set probe 4 to internal and select Vishay preset, then set display to 4-line and save settings. At this point all is good. However, if I now hit Save & Apply again (without changing anything) the display resets to 2-line and probe 4 changes to Disabled... Happens every time.
This seems kinda strange, doesn't seem like that should happen?
Occasionally I have had the probes reset to DISABLED and the display setting change from 4-line to two line. It's not a big deal cause if I change them back and save everything is corrected. It is a bit odd and frustrating at times though.
Today I noticed reproducible behavior that I figured I should report
I set probe 4 to internal and select Vishay preset, then set display to 4-line and save settings. At this point all is good. However, if I now hit Save & Apply again (without changing anything) the display resets to 2-line and probe 4 changes to Disabled... Happens every time.
This seems kinda strange, doesn't seem like that should happen?