Cy Robinson
R.I.P 3/14/2017
Last night at 11PM I put the lid on my new WSM and the two of us started our journey through Smokeville together.
Used MM for the fire and sand in the water pan covered with heavy duty foil. Put in 4 chunks of oak for the smoke.
The cook went well but the temps seemed a little high. The dome temp was up around 260* to 270* and the top grate temp was in the 240*250* range. I have read that a new WSM will cook hot for the first few cooks so I fought down the panic and closed the vents a little bit more.
Started with 2 pork butts just under seven lbs each on the top grate and a 5.5 lb brisket flat on the bottom. One of the butts was rubbed with Emerils "Bayou Blast" and the other butt and the brisket were put in "nekkid".
The cooker was not opened until the brisket needed to come out and then was left closed for the remainder of the 11 hr 20 minute cook. Didn't peek once!
Everything came out Greaaat!! The meat was so tender the pork fell apart when we pulled it and the beef was moist and so tender we cut it with our forks.
The brisket got to 197* at 0700 this morning so I took it out and double wrapped it in foil and a blanket and put it in the cooler. Three plus hours later we had fried eggs and potatoes and the best brisket, still very warm, that I have ever eaten.
The pork hit 195* just before we sat down to breakfast so we took it off and just let it rest, uncovered while we ate.
We had almost 2 lbs of sliced brisket to bag and freeze and four 1.5 lb bags of pulled pork to freeze plus a good sized bowl for sammiches later in the day.
The brisket has a very pronounced smoke flavor, more than the pork. Was 4 chunks of smoke wood too much or is it just because the brisket was closer to the fire?
Anyway, thanks to all who helped me. Without you I'd still be holding a brisket over the fire with a wet stick. /infopop/emoticons/icon_biggrin.gif
Used MM for the fire and sand in the water pan covered with heavy duty foil. Put in 4 chunks of oak for the smoke.
The cook went well but the temps seemed a little high. The dome temp was up around 260* to 270* and the top grate temp was in the 240*250* range. I have read that a new WSM will cook hot for the first few cooks so I fought down the panic and closed the vents a little bit more.
Started with 2 pork butts just under seven lbs each on the top grate and a 5.5 lb brisket flat on the bottom. One of the butts was rubbed with Emerils "Bayou Blast" and the other butt and the brisket were put in "nekkid".
The cooker was not opened until the brisket needed to come out and then was left closed for the remainder of the 11 hr 20 minute cook. Didn't peek once!
Everything came out Greaaat!! The meat was so tender the pork fell apart when we pulled it and the beef was moist and so tender we cut it with our forks.
The brisket got to 197* at 0700 this morning so I took it out and double wrapped it in foil and a blanket and put it in the cooler. Three plus hours later we had fried eggs and potatoes and the best brisket, still very warm, that I have ever eaten.
The pork hit 195* just before we sat down to breakfast so we took it off and just let it rest, uncovered while we ate.
We had almost 2 lbs of sliced brisket to bag and freeze and four 1.5 lb bags of pulled pork to freeze plus a good sized bowl for sammiches later in the day.
The brisket has a very pronounced smoke flavor, more than the pork. Was 4 chunks of smoke wood too much or is it just because the brisket was closer to the fire?
Anyway, thanks to all who helped me. Without you I'd still be holding a brisket over the fire with a wet stick. /infopop/emoticons/icon_biggrin.gif