open lid/manual fan bug


 
T

T Hayes

New member
I think I found a minor bug. The heatermeter had detected an open lid condition. During the 240s countdown I went to manual fan mode. This caused the 240s counter to stop counting, and during this time I was unable to adjust the fan speed manually. The only way out of this mode of operation was to take it back out of manual fan mode which started the timer counting again.

Not a big deal and there is a workaround, but just thought I would bring it up to see if anyone else ran into the same thing?
 
Yah know, I kinda noticed that same behavior when I was trying to setup my new servo damper recently, but I was so intent on getting the servo working I forgot all about it. I was putting the fan into manual mode to test the damper limits and one time I think I had the HM in lid mode, must be when I noticed the problem....
 
You must log in or register to reply here.

 

Back
Top