It looks like switching to a Pi Zero has successfully resolved my dropout issues, so now I have a couple small questions.
1) The link meter home page used to continuously update every second or two. It still does in Safari on an iPhone, but in edge (puke) it updates much slower and Chrome no longer updates. Is there a Chrome browser setting I need to adjust or did this get killed by a patch or update?
2) I used to be able to get the PID debug info by hitting P. It doesn't work in anymore in any browser I have tried. Is this an HM update, or a browser issue as well?
3) If my pit probe temp gets too hot at ~550-650 it will drop out and the HM LCD reports no pit probe. It comes right back after if cools down a bit. Is there limit with the HM thermocouple hardware or software, or is this something I should investigate further? I have ruled out the thermocouples I am using as I have the same issue with a half dozen of them, and they all work fine with two other devices up to 900 plus.
1) The link meter home page used to continuously update every second or two. It still does in Safari on an iPhone, but in edge (puke) it updates much slower and Chrome no longer updates. Is there a Chrome browser setting I need to adjust or did this get killed by a patch or update?
2) I used to be able to get the PID debug info by hitting P. It doesn't work in anymore in any browser I have tried. Is this an HM update, or a browser issue as well?
3) If my pit probe temp gets too hot at ~550-650 it will drop out and the HM LCD reports no pit probe. It comes right back after if cools down a bit. Is there limit with the HM thermocouple hardware or software, or is this something I should investigate further? I have ruled out the thermocouples I am using as I have the same issue with a half dozen of them, and they all work fine with two other devices up to 900 plus.