<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content">Donald, is that WSM on casters? If so, please tell me how you did it and what you used.
Thanks </div></BLOCKQUOTE>
Mike:
Yes my WSM is mobile as of this morning. I don't know how to link to a post but here's the thread I put some pictures of the build on:
Roving WSM
I used 1/2 electrical steel conduit and bent it with a pipe bender:
Er, well more like:
Home Depot sells the bender in the electrical section. I think this is the model number: 74-047.
I used the outline of the WSM lid as an outline to bend the pipe to that circumference then chisel and hammered one end of the pipe to fit into the other.
Next time I would first hammer the end of the pipe end before I bent it; much easier to hammer on a straight pipe.
I mounted threaded casters into the drilled pipe and supports with lock nuts. I had to hammer down the pipe on one side to get the nuts to catch.
And that was it, took me about 45 minutes and this baby is on the roll.