Better safe than sorry. Screw size on 4.3 Case?

[Jeremy_D]

I know, I know such a lame question when all this cool tech talk is going on here. I just would really hate to split the case as I'm not sure how well these printed boxes hold up. I purchased the HM 4.3 kit online and it didn't come with the two screws to hold the case closed so I'm wondering if anyone knows the correct size to use. If I shouldn't be that worried about it, feel free to tell me that too and I'll try some I have on hand. Thanks in advance.

Jeremy

 

[Steve_M]

According to this, it's 2x M3 nuts and 2x M3 socket cap screws, 25mm-30mm

 

[Jeremy_D]

Thank you Steve! I didn't think to look on the print plans page. I was looking for the case info on the Github site and the Sticky, but didn't cross my mind to check there.

Jeremy

 

[Bryan Mayland]

It also says on the store page.

* Closes with 2x M3x25 screws and M3 nuts (included)

Misprints - "... Hardware is not included-- you'll need M3x25 socket cap screws and M3 nuts to complete construction."