Hi all:
I've recently purchased a 4.2.4 (rpi B) from the store. I have everything assembled and am waiting on a case I ordered. I can power up the rpi via its micro-USB, and everything seems fine. But if I instead use the 12V power on the HM, neither the LCD nor the linkmeter web interface comes up.
With the 12V supply plugged in, I checked a few voltages on the board using Byran's troubleshooting "map." I see 12V where I'm supposed to, but the 5V sites are only getting around 1V. I assume I've got a bad solder, or possibly a short, somewhere. Any tips on where I should start looking?
Thanks!
I've recently purchased a 4.2.4 (rpi B) from the store. I have everything assembled and am waiting on a case I ordered. I can power up the rpi via its micro-USB, and everything seems fine. But if I instead use the 12V power on the HM, neither the LCD nor the linkmeter web interface comes up.
With the 12V supply plugged in, I checked a few voltages on the board using Byran's troubleshooting "map." I see 12V where I'm supposed to, but the 5V sites are only getting around 1V. I assume I've got a bad solder, or possibly a short, somewhere. Any tips on where I should start looking?
Thanks!