Mike Corson
New member
Hi all:
I just completed the hardware build for a 4.3 with a RPI3 B. The hardware and firmware all boot up and everything appears to be working. Yeah! However, I am unable to see it on my wireless network.
I dL'd the firmware with the wireless gateway name and pw on the download page.
I used the settings, Client, and WPA. I checked my router and WPA appears to be how my wireless router is set.
The HM boots up with an IP address of 192.168.201.1
That appears to be outside my wireless routers begin and and end IP range.
Could that be my problem?
I've reset and rebooted my HM several times and the result is the same IP address.
What settings or what additional tests can I do to get the HM to show up on the
wireless network?
Can I access the RP3 to change the static IP address? If so, how?
See my settings below.
Thank in advance!
Router : Aris ATT NVG589
Settings:
WPA
Device IPv4 Address 192.168.1.254
DHCPv4 Netmask 255.255.255.0
DHCP Server On
DHCPv4 Start Address 192.168.1.64
DHCPv4 End Address 192.168.1.253
DHCP Leases Available 177
DHCP Leases Allocated 13
DHCP Primary Pool Private
Secondary Subnet Disabled
Public Subnet
Cascaded Router Status Disabled
IP Passthrough Status Off (private IP address)
Interfaces
Interface Status Active Devices Inactive Devices
Ethernet Enabled 5 0
Wi-Fi Enabled 13 0
HPNA Enabled 2 0
I just completed the hardware build for a 4.3 with a RPI3 B. The hardware and firmware all boot up and everything appears to be working. Yeah! However, I am unable to see it on my wireless network.
I dL'd the firmware with the wireless gateway name and pw on the download page.
I used the settings, Client, and WPA. I checked my router and WPA appears to be how my wireless router is set.
The HM boots up with an IP address of 192.168.201.1
That appears to be outside my wireless routers begin and and end IP range.
Could that be my problem?
I've reset and rebooted my HM several times and the result is the same IP address.
What settings or what additional tests can I do to get the HM to show up on the
wireless network?
Can I access the RP3 to change the static IP address? If so, how?
See my settings below.
Thank in advance!
Router : Aris ATT NVG589
Settings:
WPA
Device IPv4 Address 192.168.1.254
DHCPv4 Netmask 255.255.255.0
DHCP Server On
DHCPv4 Start Address 192.168.1.64
DHCPv4 End Address 192.168.1.253
DHCP Leases Available 177
DHCP Leases Allocated 13
DHCP Primary Pool Private
Secondary Subnet Disabled
Public Subnet
Cascaded Router Status Disabled
IP Passthrough Status Off (private IP address)
Interfaces
Interface Status Active Devices Inactive Devices
Ethernet Enabled 5 0
Wi-Fi Enabled 13 0
HPNA Enabled 2 0