Page 2 of 2 FirstFirst 12
Results 11 to 11 of 11

Thread: Frame Square Nut Connector

  1. #11
    New Member
    Join Date
    Jun 2018
    Location
    Kentucky
    Posts
    5
    Sorry, I won't buy into that Photo bucket crap. It's so old school, BBS, and money based. Soo... the 7/8" rubber bumpers (from THD) have been inserted in the center by the 1/4" all thread. The small end of the taper plugged into the tube to keep the it centered. The all-thread is the strength member. File down the thread ends at the locking nuts under the original black plastic washers after tightening So no picture, not my fault.

    This table leg end fix is good and will last a while I'm sure. My tubes are rusted and won't even probably hold more than a couple of grill moves.
    Thanks all.

    Bob
    Last edited by Bobert; 06-26-2018 at 04:51 PM. Reason: photo bucket

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •