Mike Smith DFW
TVWBB Member
right now Im just using the P factor, and not I or D.
with my old iq120, it would blow the fan, wait a few seconds to a minute, activate the fan again, until temp was reached and it would basically maintain it.
with the heater meter, using the same air inlet as the iq120, when the HM shows low temp, it activates the fan, the temp cools a little, so it increases fan output, which cools temps a little more, which increases fan output.
Its basically a mess.
is it possible to have a pause in the output of the HM to allow the pit temp to start rising?
THANKS
with my old iq120, it would blow the fan, wait a few seconds to a minute, activate the fan again, until temp was reached and it would basically maintain it.
with the heater meter, using the same air inlet as the iq120, when the HM shows low temp, it activates the fan, the temp cools a little, so it increases fan output, which cools temps a little more, which increases fan output.
Its basically a mess.
is it possible to have a pause in the output of the HM to allow the pit temp to start rising?
THANKS