Adam B in Nebraska
New member
Hello, Im trying to put together a small HeaterMeter with a Raspberry Pi Zero w, Arduino Nano and a Maverick PR-005 probe.
I'm having trouble with the Raspberry pi resetting and coming back up in AP mode. I believe i could possibly have a wiring
issue with the probe wiring because it only does it when the unit is powered down and probe setup plugged into the breadboard and powered back up.
The other thing I was wondering is if the Pi's 3.3 volt line can't handle running the Arduino Nano and the probe at the same time?
I Have the probe wiring 3.3 volt line to 100k ohm resistor to center pin in probe jack with in split with 10k ohm resistor in the line to analog input with a 0.1 u capacitor to ground.
Also Im a little confused on how do I include pictures in these post from a mac?
Thanks,Adam.
I'm having trouble with the Raspberry pi resetting and coming back up in AP mode. I believe i could possibly have a wiring
issue with the probe wiring because it only does it when the unit is powered down and probe setup plugged into the breadboard and powered back up.
The other thing I was wondering is if the Pi's 3.3 volt line can't handle running the Arduino Nano and the probe at the same time?
I Have the probe wiring 3.3 volt line to 100k ohm resistor to center pin in probe jack with in split with 10k ohm resistor in the line to analog input with a 0.1 u capacitor to ground.
Also Im a little confused on how do I include pictures in these post from a mac?
Thanks,Adam.