Search results

https://heatermeter.com/dl/snapshot/full/openwrt-rpi.gz try that, its a download

https://i.ibb.co/Sd01qmQ/20150602-135907.jpg first photo is the burner, 3/4" pipe, 2nd photo link shows copper pipe off bottom of burner where damper/fan fits. Fitting on vent is my old fan connection used before I got damper.

try here https://tvwbb.com/showthread.php?48785-Fan-mounting-location-on-Weber-One-Touch-Kettle

try it without the vortex and see what happens...........I have no vortex in my 22.5 and can reach temps over 350 no problem with a HM.

for the cost, I went with the zero-w......$10.00 cad works great for me.

here's what I use on my WSM 22.5 B=0; P=4; I=0.02; D=5 Fan pulse; min 0%; max 30%; max at startup Servo 700 - 2110 top vent is always wide open My burner uses 3/4" copper pipe

my top vent always wide open.

I use a roto damper on my WSM 221/2 with home built burner with no problems.

lol thats what that button is for lol will try the ipconfig, thanks

how do you flush?

here's what I use on my WSM 22.5 B=0; P=4; I=0.02; D=5 Fan pulse; min 0%; max 30%; max at startup Servo 700 - 2110

boy you lost me here!

if it worked when you move the signal wire, you have a break somewhere in that wire or a bad solder joint there.

will need the mosfet replaced, me thinks

the faceplate on rotodamper isn't screwed down too tight is it?

did u turn the contrast pot?

Brian, which maverick probe required was it that if pushed all the way in would not work, you had to back it out abit? Maybe thats his problem??

If you can open the jack on the themocouple, check the wires for shorts and retighten the screw terminals.

these are my settings B=0; P=4; I=0.02; D=5 Fan pulse; min 0%; max 30%; max at startup Servo 700 - 2110

I never go by temp alone, it's done when you can stick a bbq fork or something similar in and when you pull it out there is no resistance or meat holding the fork. like a hot knife into and out of butter.