I think I have seen a thread in the past, but I couldn't find it when I search for it. At the moment I tend to use Evernote and include the full configuration URL and a screenshot of the graph, but this seems inefficient. What do other people use?
Basically this part of the wishlist:
- Archive...
I run a WSM 18 and I bought the Weber adapter from BBQ Guru (https://www.bbqguru.com/storenav?CategoryId=2&ProductId=6) and use a RD3 (RotoDamper3). I am planning on doing my first brisket tomorrow and can take a picture of the connections is you want.
From your home network open a browser and point to http://heatermeter.com/devices/
This will help if you missed the IP when it flashed on the LCD.
Is your HM using wifi or hard wired?
That link failed with the same error, so I put a fresh image on another SD card. What is the best way (if there is one) to recover the various configs from the old one (alarms, e-mail, etc). Or do I just start over and keep a backup elsewhere going forward?
NOTE: I DID generate a backup before...
Failure - I just tried applying this and failed. The main monitor page comes up, but if I click any of the links along the bottom (Login, Alarms, Archive or Configuration) I get the following error:
/usr/lib/lua/luci/dispatcher.lua:354: Access Violation
The page at 'admin/lm/home/' has no parent...
Thanks. Unfortunately, I was 't paying enough attention at the end of the cook. I will test both my meat probes. Did you notice it all the time, or was it sporadic once it started happening?
Thanks,
-Mark
Bryan - thanks for responding. I saw the noise icon at the beginning, but it went away. I will probably wait till I am done with this cook and then do an ice bath test on both meat probes with and without extensions. The meat 1 probe and corresponding pork butt are currently wrapped in foil in...
I currently have 2 pork butts on a WSM 18. I have pulled one and is sitting in a cooler and I am seeing 70 degree temp swings. I have an HM 4.3 with thermoworks thermister meat probes with a thermoworks extension. I removed the extension and see the same behavior. My initial through is a probe...
No, I had the unit in the house, checking on some servo issues and then moved it outside, so it has been power cycled. Thanks for looking into and finding this.
Thanks, but not a huge issue for me. I did have a stash backup, so I think I only actually lost one cook. I'll probably just sftp them back up there once my current cook is done. I can check the logs if you think there might be something there and you can point me in the right direction... I am...
I am new to HM. I had about 5-6 cooks stashed in the archive and had my HM powered down while I was out of town (7 days). I powered it back up today and they are gone. I sshed into the unit and the whole stash directory is gone. I figure they are lost for good (if I am wrong that would be...