Recent content by Jake.Br

Success!! Bryan thank you so much for your hard work in getting this running for the community. Sometimes I run another RPI on port 80 so I'd like to change my port. I entered the code below on the Startup tab, but does not seem to be applying on reboot. When you get bored could you let me...

Bryan, thank you for all your hard work! I've gone to the snapshot page, filled in my info, and downloaded the image but it will not connect to my network. The LED says na12 on it about 20 seconds after bootup. Good news is I also downloaded the AP image and that worked fine, but I want the...

Got mine and got the header soldered on. I was hoping it would just work magically. I'm hoping you big brains figure it out soon.

Yeah I tried the reset on the LCD. I used diskpart to delete all the partitions, created a new one, and did a full format. I screwed up a bit by not wiping browser cache so that may account for some of the false reading I was seeing. The RPI still connected to the network on its own dont know...

So I just did that. I deleted all the partitions that were created. Created one large partition. Wrote the image to the SD card. Booted up about a min later it connected to my network. I accessed it using the port that I had originally set it on (225). So again something is telling me...

My HM was running great for a couple weeks so much so that I told everyone I knew about how great it was. So I told a friend he could borrow it to prove how great it was. I took it to his house got it connected to his router and calibrated his iGrill probes. It worked great at his place (his...

Did a quick smoke on a Trip Tip and the HM performed flawlessly.

It works BUT So I replaced IC4, Q1, and C12 ……..ohhh no I put a 47u/10 in the 100u/10 slot. I didn’t realize this mistake till I was drafting this post and went to the Assembly to get the part numbers. Sadly I really mangled the S*** outta the board removing the cap, putting the new cap in...

The jumper worked... kinda. The HM boots but the fan still runs full-time. Here's my updated config. https://goo.gl/photos/hexkBSYiRYoW5AMV7

Thanks Steve, I'll give that a shot. That will tell me if I've killed IC4 correct? And HOPEFULLY fix my fan issus.

I probably killed the cap to. So I'll order those two parts. Is there anything else I should get as a backup?

John, thank you for your reply. Im not trying to offend, but I double checked the installation guide and only the 100/10 looks like it's backwards. I flipped it and now the board doesn't boot up at all. I get black blocks on the display and web says HM board not connected. Here is the new...

I cleaned and reflowed everything and it's a no go. Here is the other side of my board. https://goo.gl/photos/SeqXX9fJbyYwRzkNA

I'll take Pics tonight when I get home. So just scrub and all that extra junk will come off? I really struggled at the beginning, the only soldier I had was about the thickness of pencil led and was taking forever to melt so about halfway through I went and bought some solder that was about...

Thanks for the detailed response. I changed the fan to pulse mode and that did not correct the problem. Here is a pic of my board along with the readings I got while the fan was 'off' and 'on'. I hope the link works. ok so after looking at the image of my board I should probably test the...