Well, it isn't the display that is bad. I realize lived it today and same results.... Guess I should really do a little more digging. Besides that, everything works.
Got the blower plugged in, it works. I ordered a new display and the servo today. So far, everything on this works but the display. I hate it, but love the fact that it is running.
Side note, for some reason, probe one turns off. Will have to mess around and see why this is.
Still haven't gotten around to getting the display, but I did get my thermocouple and my cooking probes. Got them plugged in and everything is registering on my HM page. All 3 probes show the same temp and the thermo shows if 1 degree warmer. I think I will get the blower setup to see if that...
I can turn the LEDs on and off through the software. I can't see the screen and don't know what "menu" I'm on. I did t set up them up in the SW yet, it is all mostly default.
Time to get the darn meter out.
I'll reflow them again.
Good thing is, I know the HM works. It talks with the software and I can control everything. I can even dim the display. I have to either have a bad solder joint that I can't find or a maybe a bad display chip. Either way, it's fixable.
Yes I did. I went minimum to maximum. It is really odd. Everything seems to be working but the display.
When it is connected to my network I can even do fan adjustments and see the probes (which I bought all 4 of them today) as being there. I don't know what is going on.
My display lights up, but I have no text on it. I get 2 lights at Green and Red. If I press the left button the yellow turns on. It is connected via WiFi and is communicating. If you look at the screenshot of the software, when the yellow LED is on, that is the yellow on the graph. I double...