Recent content by Dan Seaver

Thanks guys! I am up and running! Dan

[SOLVED]HeaterMeter 4.0 Software how to start from scratch I have a heater meter 4.0 board and would like to update to the latest firmware and openwrt. I have tried several times and I don't seem to get a clean install. For example the user root still has my password...so it restored it...

Bryan, Thanks for the reply. I had an et-732 probe in the pit jack...all meat probes were et-72 high temperature probes (brand new). I did not have any issues with the ET-732 pit probe, from other postings I am aware of the mystery symptoms...I think I started a thread regarding the drop out...

I just did my first low and slow cook and I had two issues that I need help troubleshooting. 12 hours into the cook one of the meat probes dropped to off (probe2). I had probe1 and probe2 in service. So to see if it was an issue with the probe...I pulled probe2 and moved it to probe3 and I got...

Thanks Bryan! I didn't realize I had that option in my router. I have a dlink and it looks like they refer to this as a virtual server. Thanks again! Dan

In preparing to forward the ports for outside WLan access, I noticed that the default webserver ports are 80 and 443. Is there a way to change these port numbers as I already have them forwarded on my router to another PC. Thanks, Dan

Thanks for the suggestions everyone! I put the probes in a mug with boiling water and I had no drop outs. So at this point I am good to go. I need to order some additional probes, so I will make sure to order the recommended 73 probes. Thanks for all you help. I now have to figure our my...

I saw the issue about pushing them in too far, so that is not the issue. What does replacing the resistors do if I end up changing probes in the future. I knew 732s were not recommended....but I already had them. Again I was just testing on the countertop so it was reading 70 degrees F....is...

Good afternoon, I just completed my first heatermeter build V4.0 for the raspberry pi. I powered everything up on my counter top and have noticed that I get an intermittent drop of the pit temperature reading...maybe for a second or so and notice that the blower stops and then starts right...