So teardown is going well and parts are ordered. I've been reading previous posts for a few months so I think I've got the basics down but I have a few questions
1. I see a little rust on the frame so I'm going to sand it but when I paint the frame should it be with high heat spray paint like the box or some other paint.
2. The control panel is in good shape but had a few nicks in it (one of the top and a few along the edge) what should I do to seal these up so they don't start to rust and become a bigger problem.
3. I'm following the instructions on restoring the Weber emblem from Chris Allingham's blog but I don't know how to remove the friction clips and will they be usable again if not where do I buy another set?
Thanks
hopefully here are some pictures of my grill and work so far
1. I see a little rust on the frame so I'm going to sand it but when I paint the frame should it be with high heat spray paint like the box or some other paint.
2. The control panel is in good shape but had a few nicks in it (one of the top and a few along the edge) what should I do to seal these up so they don't start to rust and become a bigger problem.
3. I'm following the instructions on restoring the Weber emblem from Chris Allingham's blog but I don't know how to remove the friction clips and will they be usable again if not where do I buy another set?
Thanks
hopefully here are some pictures of my grill and work so far