Voltage Fan on 4.3 and Damper-only Setup

[Karl Tinsley]

A few quick questions:

1. Can the 4.3 run the blower in voltage mode? The wiki says you must use a 4.2, but I don't know if that means 4.2 and higher, or if only the 4.2 version has this ability.

2. For low and slow cooks on my egg, I would like to try using damper only unless the temp drops too far. Do I do this by changing the min% on the fan? If so, what would be a good starting value to try?

3. On the web interface, there are two charts, but the lower one just looks like a more compressed version of the top one. What is its purpose?

Thanks!

 

[RalphTrimble]

1) v4.2 and above supports voltage mode
2) the ON ABOVE setting is the one you want. Example, if you set blower on above 50% it wont come on until the HM hits 50% output.
3) you can click and drag on the lower chart to make the top chart zoom in on a certain area of the graph

 

[Karl Tinsley]

Thanks Ralph!