Refreshing a plastic performer table

[Kyle in Woodstock]

Had a really junky stained plastic Performer table. I tried pressure washing it, and that didn’t do much.
Tried scrubbing hard with Simple Green, again not much improvement.
So then I pulled out a sander and some 80 grit sandpaper. I think if you used a higher grit it would take a long long time.
I wasn’t expecting to have a like new table, but it turned out nice.
After sanding I wiped off dust with clean rag, then soaked the table with 303 Protectant spray and wiped off with towel.

Before




After

 

[Bob Swaskoski]

Very nice! My table is holding up okay so far but I'll remember this refresh technique when the day comes.

 

[Karl Quist]

Hey, that's not so bad! I've been thinking about doing some work on mine. I would have never thought of sanding it though, so I'm glad you posted this.