Needed for Genesis Jr (XXI)


 
HankBates

HankBates

TVWBB Super Fan
Panel.JPGClip.JPG

I need the panel and manifold bracket, and either the support rod holder or the support rod slide rail.

manifold bracket.JPGSupport rod assembly.JPG
 
Last edited:
Hank, you may get lucky by calling Weber. You found the part #'s so it's worth a shot if you haven't tried already.
 
If those are all the same as used on a Genesis 1000, I could help you out with everything except the igniter panel.
But, I don't think you will need that support rod holder clip if you have the slide assembly.
 
The flip up table is on the right hand side on the Jr. and the hardware for that is L or R side specific. I don't know if the rod holder clip is though.
 
I am sure I have a few of the rod holder clips. But, I cannot guarantee they are for both right or left tables. As far as I know, they are universal.

Clip.JPG
 
Steve Hoch said:
The flip up table is on the right hand side on the Jr. and the hardware for that is L or R side specific. I don't know if the rod holder clip is though.
Click to expand...
I’m pretty sure that the clip will work on either side and on my two x000s I’ve used lh slides on the right just by adding a notch.
I’m thinking of making an igniter support from a three sided panel as used on silver 3 burners
Thanks for all the great responses!😊
 
I added the notch to the other end and didn’t flip it over. The slider doesn’t catch at the wrong end for the same dimension reason which made it necessary for Weber to use the clip rod holder. They must have had a reason for having rights and lefts of the slider bar, maybe it was just so it would look neater....
They changed the rod itself when they started putting the slider on its end, by flattening it so the slider would not come off. I only have the old version so maybe just a clip is best ( more original too).
 
Last edited:
HankBates said:
I’m pretty sure that the clip will work on either side and on my two x000s I’ve used lh slides on the right just by adding a notch.
I’m thinking of making an igniter support from a three sided panel as used on silver 3 burners
Thanks for all the great responses!😊
Click to expand...
Looks to me that the best approach to making an igniter panel would be to start with the long front panel from a Genesis 2000 (or perhaps even a Silver C) and drill a hole for the igniter and cut off the left end. Anyone have dimensions or already done this?
 
I think the wrap around panel is your best bet for stability, I don't think a regular panel will hold up to pushing in the igniter unless you bolt it on instead of using the pushpins. As far as the hole, make it the same size as the one on a Genesis 1000 and the igniter should fit in it perfectly I would think.
 
You must log in or register to reply here.

 

Back
Top