guru controller dead

[Jeff Davidson]

after six years of steady use my guru controller died. Unfortunately, replacement cost is much higher than my orginal cost (bought new wsm package with fan for $157 on ebay).

I think the cost effective replacement is just to buy a digi q but I need to find out if my fan is compatible with the new controller. I am toying with the idea of a stoker.

anything else to consider?

 

[RobM (YankeeRob)]

Guru blowers only work with guru systems. Same with the probes. Assuming you have the probes and blower in working condition the least expensive option would be probably a Nano-Q. Just ask Bob if your probes/blower is compatible with that unit.

If you have to buy a brand new setup then a stoker is your best choice by far. You might try asking Bob if they can repair the unit. I would try taking it apart and cleaning the ciruit board with isopropal alchohol. It could be something as stupid as a shorted probe. Snap a voltmeter on the output of the wal-wart and make sure you are getting 12vdc. Good luck