Just assembled my heatermeter for its first use, and I know the fan works because on manual mode it blows and then stops when i turn it off. This just leaves the configuration in the web based Linkmeter page.
My understanding is that it should blow the fan when the pit is below the set temperature. For practice Ive set it slightly above room temperature and im warming the probes by hand to go above and below the set temp, but the fan does nothing.
Is there a way to designate one of the probes as the pit temp, and have the fan trigger from that? I suspect that is the part im missing since other probes might be set to measuring the actual meat and not be included in the fans behavior setting
thx
My understanding is that it should blow the fan when the pit is below the set temperature. For practice Ive set it slightly above room temperature and im warming the probes by hand to go above and below the set temp, but the fan does nothing.
Is there a way to designate one of the probes as the pit temp, and have the fan trigger from that? I suspect that is the part im missing since other probes might be set to measuring the actual meat and not be included in the fans behavior setting
thx