Canadian Bacon Question


 

Jim Babek

TVWBB Pro
I had a pork loin sitting in the freezer so I mixed up a batch of brine from the Dizzy Pig website minus the juniper berries and their rub. I injected the loin and its been in the brine for a week now. Im planning on smoking it up tomorrow but would like some comments.

They say to smoke it at 225 till 140 internal. That seems a little hot for the smoker when doing bacon. Perhaps I should shoot for 190-200 till 140-145. I should add that I will be frying this before eating. Another question is how many hours will all this take.

Thanks in advance for any help.
 
Went back and did a search and found this for canadian bacon. One thing else about loins make sure they are not prebrined. MOst vacumn sealed loins have been prebrined and usually don't work well for making the bacon.
posted September 17, 2002 08:21 AM
Here's a recipe I use that's similar to Joe's. I've made it a couple of times when whole loins were dirt cheap and I had a freezer full of them. While my results were closer to a mild ham than Canadian Bacon, the meat was still very good.

This is a tough recipe to make on a WSM due to the stable low temps over a long period required to cure the meat. The WSM wants to run hotter than what the recipe calls for. About a one pound coffee can of hot coals at any one time is all that's needed for heat. Making Canadian Bacon is probably better suited to a Cookshack than a Bullet. Nevertheless, this was still a fun project to experiment with.



Canadian Bacon

(Makes up to 25 pounds of pork loins)

5 quarts of ice cold water
8 ounces cane syrup (corn syrup, molasses, honey or 1/2 cup packed brown sugar)
3 tablespoons Tenderquick
4 ounces table salt

Trim all visible fat from the loins and keep cold.

Weigh the loins to determine the amount of brine to be injected into them. Dissolve the above ingredients in the cold water. This can be simplified by dissolving the sweetener, TQ, and salt in a cup of boiling water before adding to the remaining cold water. A few ice cubes will also help keep the brine cold.

Inject the loins with 10% of their weight with the brine. (I found the loins to be fully saturated with about half that amount, however.) Pour the remaining brine into a non-reactive container and place the loins in the brine and cover with an airtight lid. Store loins in the fridge for seven days; stir the loins at least once every day to ensure all surfaces of the meat are exposed to the brine.

Preheat smoker to 130 degrees.

While the smoker is coming to temperature, remove the loins from the brine, rinse with fresh water, and pat dry with paper towels. If desired, press cracked pepper into the surface of the loins. Wrap each loin tightly in cheesecloth to maintain their shape and secure the ends with twist ties.

Put the loins in the smoker for about 4 hours without smoke. (The idea at this point is to gently remove the excess moisture from the loins without cooking them through.) Increase the temperature to 150 degrees, apply smoke for 2 hours, then raise temperature to 160 degrees and continue to smoke until internal temperature reaches 142 degrees.

Upon reaching 142 degrees, remove loins from the smoker and rinse under cold running water until the internal temperature reaches 110 degrees. Remove cheesecloth and let the loins rest at room temperature until the surface is dry.

Store the meat in the fridge overnight to allow it to “tighten up” before using.


My dog is worried about the rising cost of living. Alpo is now 99¢ a can. That's almost $7 in dog money!

Posts: 194 | Location: Cedar Rapids, Iowa - You Essay! | Registered:
 

 

Back
Top